CATALOGUE FAQ
EQUIVALENT PRODUCT
Dimmer with RF 2.4 GHz remote, 4 zones, 12/24V, max. 10A
Dimmer for led strips with RF 2,4Ghz remote and 4 zones control.
- Max. power supply voltage: 24V
- Channels: 2
- Channel output current: 6AA
- Max.Load at 12V: 120W
- Max.Load at 24V: 240W
- Receiver sizes: 85x45x22 mm
ATTENTION! The kit (controller-remote) needs to be synchronized. To do it:
- Choose a zone to which You want to assign the light
- Switch off the power supply for the selected zone
- Restore power and press three times the key ‘Zone on’ of the zone you want to associate within three seconds. LEDs will flash three times and will turn off after synchronization
By restoring the power supply after a power failure affecting the controller, the LED strip (even if turned off) will turn on according to the last dimming mode.
ATTENTION: Wi-Fi connection can cause interference with the controller and, as a consequence, significantly reduce its range.
The use of shielded cables is recommended when installed near to cables plugged into the mains.
